Display Brightness - Bresser 8020402 Bedienungsanleitung

ALARM FUNCTION TURN OFF OR ON
1. In normal time mode, press [ SET ] key to switch
to alarm mode
2. In alarm mode, press [ UP ] key to turn off or on
alarm function.

DISPLAY BRIGHTNESS

For the LED display different levels of brightness
can be set as follows: bright, middle, glimmer.
(Only when operated with DC power adapter)
1. Touch and hold the upper side of the housing
(9) [SNOOZE/LIGHT] in normal display mode
for approx. 3 seconds to switch from ‚bright' to
‚middle'.
2. Repeat step 1 to change the brightness level
again as follows: from ‚middle' to ‚glimmer',
from ‚glimmer' to ‚bright', ...
The dimming function only works with the power
adapter and after the device has received the DCF
20
time signal. Once the DCF signal is received the
LED brightness can be dimmed by touching the
upper side of the housing (9) [SNOOZE/LIGHT] for
3 seconds.
ENERGY SAVING MODE
The alarm clock works in energy saving mode
when batteries are used for power supply. In this
mode the LED will not light continuously but can
be activated for approx. 1 minute by a touch of the
upper side of the housing (9) [SNOOZE/LIGHT].
Also the brightness of the LED display can not be
changed.
DATE AND TEMPERATURE DISPLAY
Automatic display change
The default setting is set to automatic display
change. The display switches every 10 seconds
(current time) or rather every 3 seconds (date and
temperature).