Zibro Kamin SRE 177 Gebrauchsanweisung Seite 50

save hour min. extension
timer save vent. fuel
t
set room
K: When the FUEL
indicator light is lit, the
information display will
show the number of
minutes of fuel left in
the tank.
save hour min. extension
timer save vent. fuel
set room
L: A blinking VENT
indicator light is a sign
that you need extra
ventilation.
M
Fuel filter
N
All manuals and user guides at all-guides.com
the 'SAVE' setting by pressing the appropriate
light up (Fig. J). Switch off the function by pressing the SAVE key once again.
Without the 'SAVE' setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
K
THE 'FUEL' INDICATOR LIGHT
When the indicator light FUEL lights up, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display ¹ (Fig. K). Now you have two options:
you remove the fuel tank and refill it outside the living room (section B) or
you push the button EXTENSION
heating time will extend to 90 minutes. The heater will automatically switch
back to its lowest position. In the display the number 90 will appear, which
will decline to 10. At the arrival of 10, you will hear an alarmsignal every two
minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches of. The fuel indicator light will blink, while four lines (--:--)
are blinking in the information display. You can stop this by pressing the
button once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDICATOR LIGHT
When the VENT indicator light starts blinking, this is a sign that the room is not
vented sufficiently (Fig. L). The heater will switch off automatically.
If the indicator light continues blinking after extra ventilation, please contact your
Zibro Kamin dealer.
M
MAINTENANCE
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains.
Your Zibro Kamin needs hardly any maintenance. It is, however, important that
you clean the air filter cap
grid with a damp cloth, both on a weekly basis. Remove the air filter cap
occasionally (Fig. M) and clean it with soapy water. Prior to reinstallation, make
sure that the air filter cap has fully dried.
Regularly inspect the fuel filter as well:
1 Remove the removable tank
(Fig. N). Some drops may leak from the filter; keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-down against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
key. The SAVE indicator light will
. By pushing this button, the remaining
and the vent filter with a vacuum cleaner and the
from the heater and remove the fuel filter
4
49
SRE 177