Winter Storage; Trouble Shooting - AEG AXP34U338BW Benutzerhandbuch

2. Wash the filter using liquid
dishwashing detergent and warm
water under 40°C. Rinse filter
thoroughly. Gently shake excess
water from the filter. Be sure filter is
thoroughly dry before replacing. Or,
instead of washing you may vacuum
the filter clean.
3. Replace the filter after the filter is dry.
Be sure filter is thoroughly dry
before replacing.

8.3 Winter Storage

If the air conditioner will not be used for
an extended period of time:
1. Drain the water collection tank
completely and leave the bottom
drain cap and rubber plug long time
enough to allow any residual water to
drain out. Once the tank is completely
drained and no more water flows out,
reinstall the rubber plug and cap.

9. TROUBLE SHOOTING

Before calling for service, review this
list. It may save you time and expense.
This list includes common occurrences
that are not the result of defective
workmanship or materials in this
appliance.
Air conditioner will not operate.
• Wall plug disconnected. Push plug
firmly into wall outlet.
• House fuse blown or circuit breaker
tripped. Replace fuse with time delay
type or reset circuit breaker.
• Control is OFF. Turn Control ON and
set to desired setting.
• Fault code P1 appears in the display
window. Drain water as described in
7.3 Drainage Section.
• Room Temperature lower than the set
temperature (Cool Mode) or Room
Temperature higher than the set
temperature (Heat Mode). Reset the
temperature.
2. Remove and clean the filter, allow it
to dry completely, then reinstall it.
3. Remove the batteries from the
remote control.
4. Store the air conditioner in a cool,
dry location, away from direct
sunlight, extreme temperature,
excessive dust, and well ventilated.
Before using the air conditioner again:
1. Make sure the filter and drain cap are
in place.
2. Check the cord to make sure it is in
good condition, without cracks or
damage.
3. Place new batteries in the remote
control.
4. Install the air conditioner as described
in the Installation Instructions.
Air from unit does not feel cold enough.
• Room temperature below 16°C.
Cooling may not occur until room
temperature rises above 16°C.
• Reset to a lower temperature.
• Compressor shut-off by changing
modes. Wait approximately 4 minutes
and listen for compressor to restart
when set in the COOL mode.
Air conditioner cooling, but room is
too warm - NO ice forming on cooling
coil behind decorative front.
• Outdoor temperature below 16°C.
To defrost the coil, set Fan mode.
• Air filter may be dirty. Clean filter.
Refer to 8. Care and Cleaning section.
To defrost, set to Fan mode.
• Temperature is set too low for nighttime
cooling. To defrost the coil, set to Fan
mode. Then, set temperature to a higher
setting.
• Exhaust duct not connected or blocked.
See 5.1 Exhausting hot air Section.
ENGLISH 21