Names Of Parts; Before Using - insta360 X3 Dive Case Gebrauchsanleitung

Specifications
Maximum Water Depth: 50m (164ft)
Included items: Insta360 X3 Dive Case, Anti-fog Inserts, 1/4'' Mount Adapter, 1/4''
Thumb Screw, Protective Pouch, Stabilizer Ring, Thumb Screw Wrench, Instructions
& Warranty
Weight: 131g ( 4.6oz)

Names of Parts

Buckle

Before Using

① Please read this document carefully and prepare the case properly before use.
Failure to observe these instructions may cause damage to the camera, battery,
microSD card or other parts, for which Insta360 won't assume responsibility. Please
use this product responsibly to prevent accidental damage.
② Improper maintenance may affect product performance. Each time before placing
the camera in the Dive Case, it's suggested to latch the Dive Case (no camera
inserted) and immerse it in water to check for leaks as described below.
• Latch the Dive Case and then slowly immerse it in water, stopping if air is expelled
from inside the Dive Case.
• Immerse the Dive Case and operate the buttons under water for 2-3 minutes,
checking for any air bubbles.
• Take the Dive Case out of the water and dry it thoroughly with a soft, dry cloth, then
open the Dive Case and check for water inside.
③ When sealing the Dive Case, be sure that the parts of the Dive Case in contact with
its rubber seal are free of any foreign objects and the rubber seal has not moved off
the rim of the Dive Case.
④ Never open or close the Dive Case in a location with a lot of sand, dirt, dust or other
small particles. Otherwise, the performance of the Dive Case will be reduced and the
camera may be damaged.
⑤ To ensure the Dive Case is securely sealed, ensure the rubber seal is not protruding
from the Case, and no foreign matter is stuck in the Dive Case once closed.
⑥ The Dive Case is not shock-resistant. Applying strong vibrations, shocks or
pressure to the product may result in damage, failure or reduced waterproofing
Button 1 Button 2
Button 3
Button 4
1