Westfalia 88 35 80 Originalanleitung Seite 33

Troubleshooting
Problem
Combi drill does not
start when Trigger
Switch is depressed
Screws do not reach
deep enough into the
Workpiece
Screws are driven too
deep into the
Workpiece Surface
Operation
Possible Cause
Battery completely
discharged
Defective Battery
Tool defective
Not enough Torque;
Torque Clutch setting
too low
Low Battery Voltage
Too much Torque;
Torque Clutch Setting
too high
29
Solution
Recharge battery or
replace with a fully
charged battery
Replace Battery
Contact the
Westfalia customer
service
Choose a higher
Torque Setting
Recharge Battery or
replace with a fully
charged Battery
Choose a lower
Torque Setting