Commissioning; Decommissioning; Maintenance; Specification - STIEBEL ELTRON SBP 400 EW Bedienung Und Installation

installation

commissioning

BGC installation in a SBP 400 E W
7. Commissioning
7.1 commissioning
Commissioning must only be carried out by a heating
contractor.
»
Fill and vent the appliance.
»
Check the functions of the special accessories in accordance with
the operating and installation instructions supplied with them.
»
Check the function of the on-site safety valve.
7.2

Decommissioning

If the heating system is not in operation and the installation
location is not protected against frost, drain the appliance and
connected system. This is relevant where there is a risk of frost.
8.

Maintenance

No special maintenance is required for the appliance. A regular
visual check is sufficient.
www.stiebel-eltron.com
9.

Specification

type
Part no.
Weight dry
filled
Height when tilted
Room height
Permissible operating pressure
connector
Ventilation
Temperature sensor heat pump return
Immersion heater
Heating flow
Heating return
Compact installation heat pump flow
Compact installation heat pump return

Guarantee

For guarantees please refer to the respective terms and conditions
of supply for your country.
The installation, electrical connection and first operati-
!
on of this appliance should be carried out by a qualified
installer.
The company does not accept liability for failure of any
!
goods supplied which have not been installed and ope-
rated in accordance with the manufacturer's instructions.

Environment and recycling

Please help us to protect the environment by disposing of the
packaging in accordance with the national regulations for waste
processing.
sBp e | sBp e sol | sBp e cool |
sBp 400 e
229300
kg 82
kg 482
mm 1800
mm 2000
MPa (bar) 0.3 (3)
G ¾" female
G ½" male
G 1 ½" female
G 2" male
G 2" male
G 2" male
G 2" male
11