Installation; Safety; Appliance Description; Sbp 700 Standard Delivery - STIEBEL ELTRON SBP 400 EW Bedienung Und Installation

installation

safety

4. Safety
All necessary steps until commissioning has been carried out must
be carried out by a heating contractor. During this process the
installation instructions must be observed.
We only guarantee trouble-free function and operational reliability
if the original special accessories and spare parts intended for the
appliance are used.
5.

Appliance description

The dimensions in the following pictures are given in mm.
Dimensions SBP 400 EW
1
12
11
10
9
8
7
1 Connector for air vent valve
2 Heating flow
3 Connector for BGC electric booster heater
4 Heat pump flow
5 Heating return
6 Heat pump return
7 Adjustable feet (3x)
8 Type plate (on cylinder casing)
9 Connector with protective pipe for heat pump return
temperature sensor
10 Steel container
11 Thermal insulation
12 Connector for BGC electric booster heating
5.1

SBp 700 Standard delivery

The standard delivery includes the following parts, packed in a
separate bag.
— Operating and installation instructions
— Detachable bezel for connecting lines
— Adjustable feet
10 | sBp e | sBp e sol | sBp e cool
11
2
3
4
5
6
11
5.2

Special accessories

Description
BGC immersion heater
WPKI 5 compact installation
WPKI 6 compact installation
6. Installation
6.1

place of installation

»
Ensure the floor has a sufficient load bearing capacity (see
Specification table).
»
Check the height of the room (see Specification table).
6.2

transport

Risk of damage
!
We recommend removing the cylinder casing during
transportation to the installation location.
6.2.1 Removing the cylinder casing
Removing the cylinder casing
1 Lid
2 Cylinder casing/thermal insulation
3 Plinth fascia
»
First remove the lid and then the plinth fascia.
6.3

positioning

»
Fit the adjustable feet provided, these are already fitted on SBP
E cool appliances.
»
Use the adjustable feet to compensate for any unevenness in
the floor.
»
Connect the cylinder casing/thermal insulation by hooking in
the closure strip.
6.3.1 Installing the BGC immersion heater
The immersion heater is used for electric booster heating.
— With the SBP 400 EW the immersion heater can be mounted on
the r.h. or l.h. side.
»
Remove the cap from the connector.
»
Undo the vent plug with an SW 32 socket spanner.
part no.
075115
220830
220831
1
2
3
www.stiebel-eltron.com