Husqvarna DM 370 Bedienungsanweisung Seite 13

The speed is automatically increased back to usual
speed 1 minute after start of the Smartstart
™
if the Smartstart button (A) is not pushed again.
Note:
Only use the Smartstart
hole. The power will be very much decreased if it is used
during usual operation.
To start the product
WARNING:
can rotate freely. It starts to rotate when the
motor starts.
WARNING:
product is started for the day, make sure
you make a check of the PRCD. Refer to
examine the PRCD on page 10 .
1. Push the "RESET" button on the PRCD. (Fig. 22)
2. To set the operation speed, turn the drill spindle and
at the same time move the gear selector. Set the
gear selector in the correct position for the operation.
(Fig. 23)
3. Make sure that the water system is open. (Fig. 24)
4. Set the ON/OFF switch to "1". (Fig. 25)
To operate the product
WARNING:
remove the drill bit from the hole before you
push "RESET".
WARNING:
occur if the concrete core stays in the drill bit
when you remove the drill bit from the hole.
WARNING:
operate the power tool by the insulated
grasping surfaces of the drill stand.
CAUTION:
hit the drill bit.
CAUTION:
necessary. This only makes the operation
slow and causes overload to the motor.
1188 - 010 - 30.11.2022
™
function
™
function to start a
Make sure that the drill bit
If this is the first time the
If the PRCD engages,
Dangerous accidents can
When you use a drill stand,
Make sure that no objects
Do not use more force than
1. Start the motor. Refer to
page 13 .
2. Let the motor speed increase to the maximum speed
before the drill bit touches the surface.
3. Push the drill bit into the surface with the feed lever.
4. If you drill through iron reinforcements, use more
initial pressure and a lower gear than if there were
no iron reinforcements.
5. Use very small pressure initially to keep the drill bit in
correct position.
6. During operation, make sure that the water removes
all waste material from the drill hole. Adjust the water
pressure if it is necessary.
7. Stop the motor. Refer to
13 .
To stop the product
To
WARNING:
rotate for some time after the motor stops.
Do not stop the drill bit with your hands.
Injuries can occur.
1. To stop the product, set the ON/OFF switch to "0".
(Fig. 26)
2. Wait until the drill bit has fully stopped.
To reset the motor overload protection
1. Stop the product. Refer to
page 13 .
2. Remove the blockage from the drill bit.
3. Start the product. Refer to
page 13 .
To replace the drill bit
WARNING:
mains outlet before you replace the drill bit.
Note:
Only use diamond drill bits that are approved for
your product. Speak to your Husqvarna dealer for more
information.
1. Make sure that you have got a new drill bit, 2
wrenches and water resistant grease.
2. Use the wrenches to remove the drill bit. (Fig. 27)
3. Lubricate the tool thread with water resistant grease.
4. Use the wrenches to attach the new drill bit.
To start the product on
To stop the product on page
The drill bit continues to
To stop the product on
To start the product on
Pull out the plug from the
13