Safety Instructions For Maintenance; Assembly; Operation - Husqvarna DM 370 Bedienungsanweisung

clutch engages again if the load is decreased and the
operation can continue. If the drill bit is caught in the
material and fully stops, the friction clutch stops the
motor immediately.
CAUTION:
time of the clutch is not more than 3-4
seconds, because if not wear and heat will
increase quickly.

Safety instructions for maintenance

WARNING:
maintenance should be carried out with
the motor switched off and the plug
disconnected.
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
Always use common sense
WARNING:
should you modify the original design of
the product without approval from the
Introduction
WARNING:
safety chapter before you assemble the
product.
WARNING:
disconnect the power cord and remove the
drill bit before assembly.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
1188 - 010 - 30.11.2022
Make sure that the release
Inspection and/or
Under no circumstances

Assembly

Read and understand the
To prevent injury,

Operation

manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
WARNING:
as cutters, grinders, drills, that sand or form
material can generate dust and vapours
which may contain hazardous chemicals.
Check the nature of the material you intend
to process and use an appropriate breathing
mask.
It is not possible to cover every conceivable situation
you can face when using the product. Always exercise
care and use your common sense. Avoid all situations
which you consider to be beyond your capability. If
you still feel uncertain about operating procedures after
reading these instructions, you should consult an expert
before continuing.
Do not hesitate to contact your Husqvarna
representative if you have any more questions about the
use of the product. We will willingly be of service and
provide you with advice as well as help you to use your
product both efficiently and safely.
Let your Husqvarna dealer check the product regularly
and make essential adjustments and repairs.
Husqvarna Construction Products has a policy of
continuous product development. Husqvarna reserves
the right to modify the design and appearance of
products without prior notice and without further
obligation introduce design modifications.
All information and all data in the operator's manual
were applicable at the time the operator's manual was
sent to print.
To attach the product to a drill stand
CAUTION:
for the drill stand carefully.
• To attach the product to a drill stand, refer to the
manual for the drill stand.
• Use only with approved Husqvarna drill stands.
Accessories on page 20 .
Refer to
2. Read the operator's manual for the drill stand
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
The use of products such
Read the operator's manual
11