Husqvarna DM 370 Bedienungsanweisung Seite 10

• Always use approved hearing protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
• The product makes dust and fumes that contain
dangerous chemicals. Use an approved breathing
protection.
• Use boots with steel toe-caps and non-slip soles.
• Make sure that you have a first aid kit near.
• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Never use a product that has faulty safety
equipment! If your product fails any checks contact
your service agent to get it repaired.
• Do not use the product if protective plates, protective
covers, safety switches or other protective devices
are not attached or are defective.
Motor overload protection, Elgard
The motor overload protection engages if the motor has
too high load or the drill bit cannot move freely.
The motor overload protection causes the power from
the motor to decrease and increase in short intervals for
some seconds. Then, if you do not decrease the force,
the motor stops. Refer to
protection on page 13 .
Load indicator
CAUTION:
again can cause damage to the product.
The product has LEDs that show the load of the motor.
LED indications on page 19 .
Refer to
PRCD
WARNING:
type sold in United Kingdom and Ireland.
United Kingdom and Ireland: Do not operate
the 110V type of the product without
an isolation transformer, refer to EN/IEC
61558-1 and EN/IEC 61558-2-23. The
isolation transformer must have a grounded
earth wire on the secondary winding side.
WARNING:
water.
10
Read the warning
™
To reset the motor overload
Product overload again and
Not applicable for 110V
Do not put the PRCD into
WARNING:
product, always do a check of the PRCD.
To examine the PRCD on page
Refer to
10 .
The product has a PRCD installed on the power cord.
The PRCD is for protection and engages if an electrical
Technical data on page 18 for
fault occurs. Refer to
information about at which current the PRCD engages.
The red light shows that the PRCD is on and that the
product can be started. If the red light does not show,
push the RESET button.
(Fig. 8)
To examine the PRCD
WARNING:
type sold in United Kingdom and Ireland.
PRCD on page 10 .
Refer to
WARNING:
examined each time the power plug is
connected to a power outlet.
WARNING:
repaired, always speak to an approved
Husqvarna service agent.
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button. The indicator above the
button is red when the current is connected.
3. Start the product, refer to
page 13 .
4. Push the "TEST" button. If the product stops, the
PRCD operates correctly. (Fig. 9)
ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
(Fig. 10)
To examine the ON/OFF switch
1. Connect the power plug of the product to the mains.
2. Set the ON/OFF switch to "1" to start the product.
3. Set the ON/OFF switch to "0" to stop the product.
Friction clutch
The friction clutch is integrated in the gearbox of the
product. It prevents damage to the product if the drill
bit stops during operation. If the load is too high, the
friction clutch is released and stops the drill spindle
but keeps the motor on for some seconds. The friction
Before you operate the
Not applicable for 110V
The PRCD must be
If the PRCD must be
To start the product on
1188 - 010 - 30.11.2022