Care And Maintenance - TFA 35.1078.10.IT - Diva Plus Funk Betriebsanleitung

The foldout table stand leg is located on the backside. Pull the
stand out from the bottom center edge of the weather station,
below the battery compartment. Once the foldout table stand
is extended, place the weather station in an appropriate
location.
POSITIONING THE THERMO-HYGRO TRANSMITTER
The Thermo-hygro transmitter can be placed onto any flat surface or wall mount
using the bracket which doubles as a stand or wall mount base.
Table stand/wall
mount bracket

CARE AND MAINTENANCE:

Extreme temperatures, vibration and shock should be avoided as these
•
may cause damage to the units and give inaccurate forecasts and
readings.
When cleaning the display and casings, use a soft damp cloth only. Do not
•
use solvents or scouring agents as they may mark the LCD and casings.
Do not submerge the units in water.
•
Immediately remove all low powered batteries to avoid leakage and
•
damage. Replace only with new batteries of the recommended type.
Do not make any repair attempts to the units. Return it to their original point
•
of purchase for repair by a qualified engineer. Opening and tampering with
the units may invalidate their guarantee.
Do not expose the units to extreme and sudden temperature changes, this
•
may lead to rapid changes in forecasts and readings and thereby reduce
their accuracy.
To wall mount:
1. Secure the bracket onto a desired
wall using the screws and plastic
anchors.
2. Clip the transmitter onto the bracket.
Note:
Before permanently fixing the remote
temperature/humidity sensor wall base,
pace all units in the desired locations to
check that the outdoor temperature and
humidity readings are receivable. In event
that the signal is not received, relocate the
remote temperature/humidity sensor or
move them slightly as this may help the
signal reception
36