Technical Data; Noise Information; Vibration Information - Kress KUA24 Bedienungsanleitung

TECHNICAL DATA

Type designation KUA24 (A24-designation of
machinery, representative of drill)
Voltage
No-load speed
Torsion adjusting positions
Maximum torque
Maximum clamping capability
Steel
Maximum drilling
capability
Wood
Machine weight
** Voltage measured without workload. Initial battery voltage
reaches maximum of 12 volts. Nominal voltage is 10.8 volts.

Noise Information

A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.
KUA24
12V Max**
0-500/0-1800/min
20+1
40Nm
10mm
10mm
20mm
0.9kg
L =82dB(A)
pA
L = 93dB(A)
wA
5dB(A)

Vibration Information

Vibration total values (triax vector sum) determined
according to EN 62841
Vibration emission value a
Drilling into metal
Uncertainty K = 1.5 m/s²
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used especially what kind of workpiece is processed
dependant on the following examples and other variations
on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but
=2.603m/s²
h,D
13
EN