Electrical Connection From Below - clage DEX 12 Next Gebrauchs- Und Montageanleitung

6. Electrical connection
A

Electrical connection from below

Note: If necessary, the connecting terminal can be displaced to the upper part of the
appliance. If you want to do so, please follow the instructions in the next chapter.
Check that the power supply is switched off prior to electrical connection!
1. Dismantle approximately 6 cm off the connecting cable above the wall outlet. With
the smaller opening ahead, slide the water splash protection sleeve over the con-
necting cable so that the sleeve is flush with the wall. This prevents any leaking
water from coming into contact with the electrical leads. It must not become dam-
aged! The protection sleeve must be used!
2. Open the control panel holder rightwards.
3. Strip the cables and plug them in the connecting terminals according to the wiring
diagram. The appliance must be earthed.
4. Pull the protective sleeve over the connecting cables until the sleeve fits perfectly
in the recess of the intermediate panel. Adjust the water splash protection sleeve as
illustrated and fix it with the sleeve fixing (A). Reinsert the control panel holder and
lock it on.
5. Place the hood on the appliance and screw in the fastening screw. After that you
can slide on the faceplate from the bottom up to the stop.
37
CLAGE
EN