Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dismantling
•
Dismantle socket head screw (3/1) with lock washers (3/3) and propeller washer (3/2).
•
Withdraw the propeller (3/4) from the propeller shaft. Remove key (3/5) from the end of the shaft.
Assembly
•
Clean carefully shaft and boss. the key to the shaft end.
ATTENTION
Do not use any products containing molybdenum disulphide!
•
Bring the groove of the propeller hub into line with the shaft key and push the propeller carefully to a stop.
•
Fit the securing washer and the propeller washer (where applicable) to the socket head screw. Ensure the correct fitting position of the
securing washers.
•
Screw in the socket head screw and tighten it to the specified tightening torque.
5.3
Tightening torque
See chapter 8.2 of the Installation and Operating Instructions 6006573.
5.4
Installation example XRW 330
We recommend that the closed bracket be used for this type of installation
7
6
4
.
5.5
Guide tube lengths (square tube) XRW/XSB-KA
See chapter 8.6 of the Installation and Operating Instructions 6006573. XRW 330 = XRW 400, □ 100 x 100.
5.6
Electrical connection
See chapter 9 of the Installation and Operating Instructions 6006573. See figure 22/23.
6 - 7
Commissioning; Maintenance
See chapter 12 - 13 of the Installation and Operating Instructions 6006573.
EN 6006544-B
1
2
3
5
Figure 4 Installation example XRW 330
Legend
1
Hoist with winch and rope
2
Upper bracket with locking plate
3
Closed bracket
4
Bottom plate
5
Safety stop clamp
6
Swivelling square guide tube
7
Cable clamp with cable hook
7
Werbung
Inhaltsverzeichnis
