Description Of The Appliance - eta ZEFIR 1607/10 Bedienungsanleitung

EN
– This appliance is not intended for outdoor use.
– Do not plug the fork of the supply cord into the power outlet and do not unplug the
cord with wet hands or by pulling by the supply cord!
– The appliance cannot be used in bathrooms in zones 0, 1 and 2 HD 384.3 S1! It
must not be used in close proximity of bathtubs, a shower or a swimming pool.
– The appliance must not be used in damp or wet environment and in any environment
with the danger of fire or explosion (spaces where chemicals, fuels, oils, gases,
paints and other flammable or volatile materials are stored).
– Use the appliance in the working position only at places with no risk of turning over and
in a sufficient distance from objects (such as curtains, drapes, etc.), heat sources
(e.g. fireplace, heater, stove, cooker, radiators, hot air ovens, grills) and wet
surfaces (e. g. sinks, wash basins).
– Make sure that impurities do not enter into the appliance (e.g. clouds of dust, hair etc.).
– Do not put the switched on fan on soft surfaces (e.g. on a bed, towels, wipers, carpets).
– There must not be any device with open flame in the flow of the air coming out from the
appliance because of danger of burning process interruption.
– Never let the flow of air blow on you (or animals) for an extended period of time. It may
cause health problems.
– Never put the power cord on hot surfaces or do not let it hang over the edge of a table or
a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or
drawing the appliance down and serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– Do not wind the power cord around the appliance, this will extend life of the power cord.
– Use this appliance only for the purpose for which it was designed as specified in this
user's manual. Never use the appliance for any other purpose.
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire) and its guarantee for the appliance
does not apply in the case of non–compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE
A – Drive unit
A1 – ON/OFF switch + airflow rate
selector
A2 – Oscillation switch
A3 – Shaft
A4 – Adjustable joint angle
A5 – Power cord
A6 – Stand
A7 – Base
III. INSTRUCTIONS FOR USE
Before first use, remove any packaging and protective material (including any protective
film) from the appliance and accessories.
ASSEMBLING:
When assembling the fan, please proceed according to Fig. 1. Prior to mounting the plastic
connecting collar A13, loosen the bolt A14 so that you could easily put the collar on the
rear and front protecting cover (A9/A15). After that, tighten slightly the bolt A14. When
demounting, please proceed in reverse order.
A8 – Locking screws (3x)
A9 – Rear grill
A10 – Grill nut
A11 – Blade
A12 – Blade nut
A13 – Plastic connecting collar
A14 – Screw
A15 – Front grill
12 / 27