Velleman RCQC1 Bedienungsanleitung Seite 9

Switch on your remote control. The LEDs
should burn steadily.
Fine-Tuning the Rotors
You can fine-tune the rotors in the unlikely case they should not turn at the same speed. To do so:
Push the fine-tune switch for the forward-
backward movement.
Switch off both the drone and the remote control and switch them on again. The rotors should be
synchronized. Please repeat if it is not the case.
11. Troubleshooting
No response from the quadcopter.

The battery of the quadcopter is insufficiently charged. Charge the battery.

The batteries of the remote control are insufficiently charged. Charge or replace the batteries.

The bandwidths of the remote control and the quadcopter do not correspond. Choose the
same bandwidth for both the remote control and the quadcopter by resetting and
synchronizing the remote control and the quadcopter.
The quadcopter is slow to respond or difficult to manoeuvre.

The battery of the quadcopter is insufficiently charged. Charge the battery.

The batteries of the remote control are insufficiently charged. Charge or replace the batteries.

The quadcopter is out of remote control's range. Do not fly the quadcopter too far from the
remote control. The range depends on the environment and surrounding objects.
V. 05 – 19/01/2016
RCQC1
Place the quadcopter on a flat surface. Push
the throttle and cyclic sticks to the bottom-
right corner until the LEDs blink rapidly.
Release the sticks. Resetting has been
completed when the LEDs burn steadily. Re-
synchronize the remote control and
quadcopter as described above.
Push the fine-tune switch for the accelerator-
9
rotation movement.
©Velleman nv