One of those stunts is the 3D flight or roll. To do so:
1.
Keep your quadcopter hovering at a steady height of minimum 3 m.
2.
Press the 3D flight button. Move the cyclic stick to the left, the right, forward or backward.
3.
You will now have completed a perfect 360° roll, left, right, forward or backward according to your
cyclic stick movement!
Only use the 3D flight with fully-charged quadcopter and remote control batteries, and in an
open-space area without obstacles.
9.
The Camera Function
9.1
Preparing the Camera
1.
Make sure the camera is connected to the quadcopter.
2.
Switch on the quadcopter. If the LED inside the camera blinks red and turns green, the camera is
ready to be used. If the LED burns red and switches off, check if the camera has an SD card or if the
inserted SD card is faulty.
9.2
Taking Pictures and Recording Video
Taking a Picture
The camera will take a picture every time you push the picture/video switch upward.
Recording Video
Push the picture/video switch downward to record. Push the button downward again to stop video
recording. Only then will the video be saved onto the SD card.
10.
Other Functions
Low-Power Protection
The blades automatically stop when the battery power is insufficient.
Over-Current Protection
When the quadcopter's blades jam, the system automatically cuts the power supply to the blades. A
power cut-off due to over-current will need a re-synchronization of the remote control and the
quadcopter.
Reset Function
Switch on your quadcopter. Wait for the
orientation LEDs to blink slowly.
V. 05 – 19/01/2016
RCQC1
Push and hold the throttle stick completely
8
downwards.
©Velleman nv