Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Factory reset by button
In case there is no OCPP backend and web interface accessible, it is possible to reset the EV charging
station by button.
To reset the EV charging station by button, proceed as follows:
1.
Open the covers of the two locks on the right side of the charging station and unlock the locks
with the keys.
2.
Open the door of the charging station.
3.
Make sure the EV charging station is turned on.
4.
Press and hold the button K1 with a pen or similar item for 15 seconds (see fig. 1).
Two signals will sound. The first signal sounds after 4 Seconds. Keep holding the button, until the
second signal sounds and release the button.
5.
The EV charger will restart automatically and will load the default (factory) settings.
6.
The EV charger is ready to be used after 20 seconds.
Format memory
If problems persist, and if our support asked you format the memory of the EV charging station, you can
perform a format as follows:
1.
Power off the EV charger.
2.
Locate the button K1 on the upper left side of the main board (see fig. 1).
3.
Press and hold the button K1 with a pen or similar item.
4.
Power on the EV charger while keeping the button pressed.
5.
Release the K1 button and press it again once.
6.
The memory will be formatted. This is an automated process.
7.
Power off the EV charger after 10 seconds and power it on again.
8
Fig. 1 Location of the K1 reset button
Werbung
Inhaltsverzeichnis
