Timer (Automatic Timer); Emptying The Water Tank; Terminating Operation; Cleaning - BOMANN CL 6061 CB Bedienungsanleitung, Garantie

Timer (Automatic Timer)

Use the timer function to set the power-on and power-off times of the
appliance. Select a time between 1 and 24 hours.
NOTE:
• If you want to deactivate the set timer operation, press the TIMER
button twice. The (1) indicator light goes off.
• You may also cancel the timer function at any time by pressing the
POWER
button to turn the appliance on / off.
Using the Timer Function for Automatic Power-On
1. Press the POWER button to turn on the appliance.
2. Select the operating mode, temperature and fan speed for the appli-
ance to operate in or at when powered on at the pre-set time.
3. Press the POWER button to turn off the appliance.
4. Press the TIMER button. The number of hours flashes.
5. You can set the desired number of hours with the
The setting mode is automatically exited after approx. 5 seconds.
Timer operation is activated and the indicator light (1) illuminates.
NOTE:
Do not press the TIMER
button after setting the hours, as the
timer operation will not be saved.
Using the Timer Function for Automatic Power-Off
1. Press the POWER button to turn on the appliance.
2. Press the TIMER button during operation. The number of hours
flashes.
3. You can set the desired number of hours with the
The setting mode is automatically exited after approx. 5 seconds.
Timer operation is activated and the indicator light (1) illuminates.

Emptying the Water Tank

The appliance integrates a water tank for collecting condensation.
When the water tank is full, the pilot lamp FULL lights up. The appliance
switches off.
CAUTION:
Do not transport the appliance while the water tank is full. Water could
get into the appliance.
In order to continue operation, you need to empty the water tank. For
this, you need a floor cloth, a flat bowl with a capacity for approx. 0.6 li-
tre of water and the water hose supplied with the appliance.
1. Disconnect the mains plug from the wall socket.
2. Place the floor towel and the flat bowl underneath the water outlet. If
possible, set the bowl on a lower level than the appliance.
3. Unscrew the swivel nut from the lower plug. Then pull the plug out.
4. Connect the water hose to the water outlet of the appliance. Place the
end of the hose in the bowl.
5. After the water has been discharged, remove the water hose. Use the
stopper to close the water drain on the appliance again. Fasten the
plug by screwing the swivel nut back on.

Terminating Operation

1. Press the POWER button to turn off the appliance.
2. Disconnect the mains plug from the wall socket.
44
CL6061CB_IM
WARNING:
• Always disconnect the mains plug from the wall
socket before cleaning!
• Make sure no water enters the openings of the ap-
pliance during cleaning. Otherwise this might result
in an electric shock or fire.
CAUTION:
• Do not spray the appliance with cleaning agents.
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
and buttons.

Filter

Clean the filter once every 2 weeks, if the appliance is in daily use. If
dust in the filter blocks the ventilation, the efficiency of the appliance is
no longer guaranteed.
1. On the rear side of the appliance, above the connection for the ex-
haust air hose, you will find a grille with a built-in filter.
2. The grille is secured with a phillips-head screw. Remove this screw
using a suitable screwdriver.
3. Vacuum the filter with a vacuum cleaner.
4. Clean the filter under running water. If necessary, use a mild deter-
gent.
and buttons.
5. Leave the filter to dry in the open air in a shady location.
6. Only put the grill back in the appliance if the filter is completely dry.
7. Fasten the grille again using the screw.
CAUTION:
Do not operate the appliance without filter!

Housing

• Use a vacuum cleaner to clean the ventilation slots.
• Wipe the housing with a slightly damp cloth.
When not using the appliance for a long period of time, proceed as
follows:
1. Empty the water tank as described above.
2. Repeat the steps 2 to 5 from the chapter "Emptying the water tank"
with the upper water outlet (top plug).
3. Operate the appliance in "FAN (Fan)" mode for 2 hours in order to dry
the inside of the appliance.
4. Press the POWER
mains plug from the wall socket.
5. Disconnect the flexible exhaust pipe from the appliance.
6. Leave both water outlets open.
7. Clean the filter and the appliance as described above.
8. Cover the appliance with foil.
9. Always store the appliance out of the reach of children in a dry, well
ventilated place.

Cleaning

Seasonal Cleaning and Storage

button to turn off the appliance. Disconnect the
07.11.22