Ritter EBT Bedienungsanleitung Seite 13

mountIng brEad bIn lId
fastEnIngs
• Place the bread bin (1) into the (inserted)
drawer.
• Shorten the supporting pipe (3) to the
correct length (inner carcass width minus
8 mm).
• If necessary, route the supporting pipe
into the lid rack (6).
• Align the supporting pipe parallel to the
bread bin lid (2) at a distance of 16 mm
(Figure D).
• Place the bread bin lid onto the bread bin:
– The "ritter" emblem should be visible at
the front.
– The bread bin lid should contact the
front of the drawer
figure d:
• Pull the drawer out far enough, so that
the supporting pipe makes contact with
the front edge of the carcass side.
• Mark the upper edge of the supporting
pipe on the left and right of the inside of
the carcass.
• Remove the bread bin lid and the bread
bin.
• Remove the drawer.
figure E:
• Use the drill template and a centre punch
to mark the following on the right-hand of
the carcass interior:
– the holes for the right retaining
bracket (10)
– the holes for the lid carrier (11)
figure f:
• Use the drill template and a centre punch
to mark the holes for the left retaining
bracket (10) on the left of the carcass
interior.
• Drill the marked holes (Ø4.5 mm x 10 mm).
InstallIng VEntIlatIon bEzEl
• Drill the hole for the ventilation bezel (7)
(Ø44 mm):
– on the rear side of the carcass
– in the centre, level with the bread bin
• Insert the ventilation bezel.
fInalIsatIon
• Insert the retaining brackets (10) into the
bores and fasten them in place using the
fastening screws (13).
• Insert the bread bin lid (2) with the sup-
porting pipe (3) into the retaining brack-
ets.
• Mount the lid carrier (11) using the fasten-
ing screw (14).
• Insert the drawer.
• Place the bread bin into the drawer.
• Check the position of the lid carrier:
– The lid carrier fits flush to the front of
the bread bin
– The lid carrier must not contact the side
of the bread bin when the drawer is
pulled out
• If necessary, adjust the position of the lid
carrier (6).
• Tighten all screws.
English
9