Installation Instructions; Delivery Contents - Ritter EBT Bedienungsanleitung

English

InstallatIon InstructIons

dElIVEry contEnts

figure a:
Pos. designation
1 Bread bin
2 Bread bin lid
3 Supporting pipe
4 Fastening screw, preassembled
5 Fastening screw, preassembled
6 Lid carrier, preassembled
7 Ventilation bezel
8 Fastening angle
9 Baseplate
10 Side retaining bracket
(supporting pipe bearing)
11 Lid supporting surface
12 Fastening screw
– ASPA Pan Head 3.5 x 17
(without baseplates)
– ASPA Pan Head 3.5 x 25
(for one baseplate)
– ASPA Pan Head 3.5 x 30
(for two baseplates)
13 Fastening screw 4x13
14 Fastening screw 6x13.5
15 Serrated lock washer
- Drilling template
prEparatIon
Remove all drawers that are located above
the drawer intended for the bread bin.
8
mountIng fastEnIng anglE for
brEad bIn
figure b:
number
• Use a stop angle to mark out a right-hand
1x
reference line in the base of the drawer at
1x
a distance of 43 mm to the inside of the
1x
carcass.
2x
4x
figure c:
2x
• Place the drill template, with the under-
side, onto the front of the drawer and
1x
with the right-hand side up against the
6x
reference line.
12x
2x
• Drill the holes with which the fastening
angle (8) is to be mounted.
1x
• Determine the maximum case height.
If the height is in excess of 150 mm, the
9x
fastening angle must be fitted with a
baseplate (9), if it is higher than 158 mm,
9x
two baseplates have to be used.
9x
• Attach the two right-hand and the front
fastening angles, using two fastening
2x
screws each (12).
1x
• Attach the two left-hand and the rear
3x
fastening angles, using one fastening
2x
screw each (12) and a serrated lock
washer (15).
Do not tighten the screws yet so that the
position of the fastening angles can still
be adjusted.
• Mount the bread bin onto the fastening
angle:
– The "ritter" emblem should be visible at
the front.
– The bread bin should make contact with
the right and front fastening angles.
• Position the adjustable fastening angles
at the left and rear so that the bread bin
can be inserted and removed easily, but
with zero-clearance, if possible.
• Secure the position of the left-hand and
rear fastening angles.