GET RX1 PRO Installationsanleitungen Seite 3

6. To use and manage GPA technology, it is necessary to
install the GET GPA Switch or the GET LC-GPA module (both
sold separately) or to manage it with GET Maya software
(sold separately).
7. To change the RX1 Pro injection map, it is necessary to use
GET Maya programming software (sold separately). Unlike
the other RX1 PROs, this ECU can only be programmed if it
is installed on the bike. Use the GL-268-AA programming
connector (sold separately) to be able to work on the control
unit alone with the help of a 12V battery.
8. If the bike won't start or the engine runs roughly, make
sure the RX1 Pro ECU you have chosen is compatible with the
model and year of your bike, make sure that the ECU is properly
connected, and always perform a TPS calibration.
9. The original Mode button (blue) can be used to manage the
GET LC-GPA when installed. In order for the GET RX1 Pro ECU
to work properly, use only the GET Map Switch (included in the
kit) and the GET LC-GPA module (sold separately).
B. HOW TO INSTALL THE GET RX1 PRO
RX1 PRO is a fully programmable plug&play ECU. RX1 PRO
is the best solution for both stock and modified engines: it is
possible to adjust the calibration map either through the WiGET
App by using the WiFi-COM device, or with MAYA software.
WiGET App
RX1 Pro comes with two maps developed by the GET R&D
department, which can be easily switched by using the Map
Switch (included in the kit).
3
EN