Motorola ROKR 820 Kurzanleitung Seite 4

6. USB CONNECTION
With your Speaker, you can enjoy music that is stored on a USB storage device such as an MP3 player.
Plug your USB storage device into the USB port of your Speaker. The music will play automatically. If not, Press Mode
button to select USB mode and press Play/Pause on the unit. Or please check if the USB device contains playable audio
contents.
7. FM RADIO
1) Press Mode button to select FM radio mode.
2) Auto tuning : Press and hold Play/Pause button on the unit for 3 seconds until the frequency indication starts to
change, then release. The unit will search and store the stations, a maximum of 30 stations can be stored.
3) Manual tuning : Press Skip-/+ button to manual select the desired FM frequency.
4) Select the stored stations: Press Play/Pause first, the display will show the stored station number, then press Skip-/+
to select the station.
8. AUX CONNECTION
1) Press Power/Source button to select Aux mode.
2) Connect a 3.5mm audio cable (not supplied) to: the headphone or audio line-out socket of your audio device and
the AUX in jack of this speaker.
3) Turn on your audio device to start play.
9. EQ MODE AND BASS/TREBLE
1) Press the EQ button to scroll through the six different EQ settings:
Eq-1 ...... Flat
Eq-2 ...... Rock
Eq-3 ...... Jazz
Eq-4 ...... Classic
Eq-5 ...... Pop
2) Press Bass Boost button to get the super bass sound.
3) If Mic 1/Mic 2 is plugged with the microphone , the EQ setting will be off. Press EQ button, the display will shows:
VOCA, DUCI, EqOF.
And the settings are as below:
VOCA: means Vocal Cut, if the display show VOCA, will cut the vocal of the music/radio. Then you can speak or sing
with the microphone.
DUCI: means Music Ducking, if the display show DUCI, the music/radio sound will duck, when you speak via
microphone.
EqOF: means EQ setting off.
10. LIGHT
1) Long Press the light button to turn on or turn off the light;
2) Short press for select LED mode for show different light effects(default setting LED 1) :
Led-1 : LED will be demo display if no music playback, if detected the music , the LED Color flash and change in
synch with the music.
Led-2 : Color flash and change in a fixed rhythm.
11. SPECIFICATION
1) DC Charge Power input
2) Built-in Battery
3) USB output
4) Speaker drivers
5) Speaker impedance
6) Maximum RF Power
7) Total Output Power
8) Signal to noise (S/N) ratio
4
12V DC/1.5A
Li-ion 7.4V/5000mAh
5V DC/1A
2 x 6.5 inches driver 2 x
1.5 inches tweeter
4 ohm
4dBm
80 W
65 dBA
9) FM frequency
10) Bluetooth Version
11) Bluetooth profile
12) Bluetooth range
13) USB format
14) USB file format
15) Dimension(WxDxH)
16) Net weight
87.5-108.0 MHz
5.0
A2DP, AVRCP
Approx. 10m
(33 feet)
FAT16, FAT32
MP3, wma, wav
11.7 x 9.6 x 24.1 inch
15.5 lbs