Maintenance - Team HC 19 R Gebrauchsanleitung

Fax +32 2 359 95 50
Styling the beard
Hold the appliance vertically in front of your face, with its front side pointing away from you.
Start with the shortest areas of the beard and cut the hair directly under the beard line moving
down.
Thinning and sharpening
Take the supplied comb and bring the beard hair in the desired shape.
Hold the appliance with its front side pointing away from you and cut the hair tips by moving
down.
To thin out the beard, push the switch upwards to the "THINNING" position and cut against the
grain of the hair.
CUTTING MOUSTACHE
With the comb attachment
•
Comb the moustache with the supplied comb so that it is as vertical as possible.
•
Slide the comb attachment to the desired cutting setting.
•
Hold the appliance horizontally in the hand with its front side pointing at you.
•
Cut the moustache by moving down.
Without comb attachment
Put your fingers on the upper lip, so that the hair of the moustache is away from the skin.
Cut the hair by moving up.
Then cut the hair by moving down to level possible length differences.
To obtain the desired outline above the upper lip, hold the appliance vertically towards the
cutting direction and move sideward.

MAINTENANCE

•
Your clipper was carefully examined before leaving our factory to ensure that the blades
were oiled and aligned. To maintain your clipper in peak condition, the blades should be
oiled every few haircuts.
•
Use the small brush to remove remaining hair.
•
Change the blades as soon as they become blunt.
DISPOSAL OF BATTERY (see page 3: D)
When you decide to throw out your appliance, first remove the battery in order to protect the
environment.
•
Press the unlocking knob underneath the appliance (21).
•
Remove the cover of the appliance carefully with the appropriate tools (22).
•
Cut the wires that link the battery with the appliance with a wire cutter.
•
Remove the battery from the appliance (23) and dispose of it in accordance with the
legislature.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
14
Assembly page 14/51
TEAM HC 19 R - 110518