Team HC 19 R Gebrauchsanleitung Seite 12

Fax +32 2 359 95 50
•
Replace the cutting head by sliding the cutting head clip into the notch on the cover of
the trimmer until you hear it snap into place.
•
Remove any excess oil by wiping it carefully with a cloth.
MOUNTING (see page 2: B)
•
To mount the comb attachment, put the sliding lock switch on the back of the appliance
in the unlock position
on page 2, B. The "clicks" that you can hear correspond to the different cutting length
settings. Once the comb attachment stops, it means that it is in position "1".
•
To remove the comb attachment, proceed the other way around, still making sure that
the sliding lock switch is in the unlock position .
•
Once you have chosen the cutting length, put the sliding lock switch in the lock position
to block the comb attachment.
To attach the comb attachment, hold it with teeth up and snap comb attachment firmly to
the appliance. The comb attachment can be set to 7 cutting length positions:
1. 1/7"
2. 1/4"
3. 1/3"
4. 5/12"
5. 1/2"
6. 7/12"
7. 2/3"
CUTTING HAIR WITH THE COMB ATTACHMENT (SEE PAGE 2: C and PAGE 3)
•
Only cut a small amount of hair to start with until you become accustomed to the length
the comb attachment gives to the hair.
•
We suggest you try the longest comb attachment in position "7" on the clipper first.
•
For uniform cutting, never push or force the clipper through the hair at a fast pace. The
clipper works most efficiently when it works at its own speed.
•
Start by combing the hair in its natural direction.
•
Place the comb attachment in position "7" to your clipper, push the switch down to the
"CUT" position and start by trimming the sides from the bottom upwards. Hold the clipper
lightly against the hair with the teeth of the comb attachment pointing up but flat against
the head. Slowly lift the clipper up and outward through the hair, cutting only a small
amount at a time (8 and 9).
•
If you want shorter hair, either place the comb attachment in position "1" or change the
hair length (see B, 6). You can also apply more pressure to the present comb attachment.
This procedure requires practice, and it is always better to leave too much hair during the
first few haircuts (10).
•
For the top of the head, you will give a fairly short cut if you place the comb attachment in
position "1". With the teeth flat against the head, slowly start trimming from the front to the
back. Again, it is better to leave the hair longer at the beginning (11).
Short cuts
•
Always cut from the back of the neck to the crown, placing the comb attachment in
position "7". Holding it flat against the head, slowly move the clipper up through the hair.
Use the same technique for the sides, cutting from the bottom to the upper side of the
head (14).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
(see page 3, E 24) and insert the comb attachment as described
12
Assembly page 12/51
TEAM HC 19 R - 110518