Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance; Disposal Of Battery - Magic MGC HC 2 R Gebrauchsanleitung

Akku - haarschneideset
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Fax +32 2 359 95 50
Short cuts
Always cut from the back of the neck to the crown, with the 6 mm comb attachment. Holding
it flat against the head, slowly move the clipper up through the hair. Use the same technique
for the sides, cutting from the bottom to the upper side of the head (14).
For the front of the crown, cut the hair against the direction in which it grows. Then even it up
with the sides (15).
To taper hair down to the neckline, use the 4 mm attachment comb. Comb hair, check for
uneven spots and outline sideburns and neckline. (16)
CUTTING WITHOUT THE COMB ATTACHMENT
To cut the hair with the help of a comb or your fingers as well as to cut the outlines, you do not
need the comb attachment.
Take off the comb attachment by pulling it holding it by the sides.
Cutting hair with the help of a comb or your fingers
Remove the comb attachment carefully, as explained in the previous paragraph.
Raise a wisp of hair with the help of the comb (17), or take the wisp between your fingers (18).
Take the wisp through the comb or fingers until only the desired hair length remains under the
comb/fingers. Cut the hair that is above the comb or fingers with the hair clipper (19 and 20).
Outlining
Outlining requires no attachments, apply directly the blades on the hair.
Comb hair into the required style. Position clipper between the sideburns and the ear. Make
sure the outer edge of the blade is against the hairline. With the outline of the hair as your
guide, slowly move the clipper around the ears (11). For the back of the neck and the
sideburns, hold the clipper upside down (13), and move downwards holding it against the
skin at the length desired. If necessary, insist on thicker hair.
After you acquired a certain experience, you'll be able to do layered cuts simply by
changing the haircut height according to the part of the head but this manipulation
requires a certain skill to obtain a good result.

MAINTENANCE

Your clipper was carefully examined before leaving our factory to ensure that the blades
were oiled and aligned. To maintain your clipper in peak condition, the blades should be
oiled every few haircuts.
Remove the blades as indicated on page 2 "A1".
Use the small brush to remove remaining hair.
Lubricate the blades as indicated on page 2 "A2".
Put the blades back in place as indicated on page 2 "A3".
Change the blades as soon as they become blunt.

DISPOSAL OF BATTERY

When you decide to throw out your appliance, first remove the battery in order to protect the
environment.
The appliance has to be disconnected from the power supply when you remove the
battery.
Remove the blades as indicated on page 2 "A1".
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
12
Assembly page 12/48
special
instruction
from
MGC HC 2 R - 080609
Team

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis