Herunterladen Inhalt Inhalt Diese Seite drucken

Before You Start - Magic MGC HC 2 R Gebrauchsanleitung

Akku - haarschneideset
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Fax +32 2 359 95 50
When you decide to throw away the appliance, make sure to remove the battery and to
dispose of it in an ecological manner. For more information contact your town authorities.
BE CAREFUL NOT TO TOUCH THE ACCUMULATOR OR THE LEAKING LIQUID.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
CONNECTING
The charging base can be connected to any voltage outlet -even to shaver sockets-
between 230-240 volts ac (-).
The red charge indicator will light up, when the appliance is charging and the green
charge indicator will light up when the appliance is charged.
The hair clipper may warm up somewhat during recharging. This has no significance on the
unit's operation. Overcharging is impossible.
To maintain the hair clipper's full performance, it should always be charged after use.
PRESERVING THE RECHARGEABLE BATTERY
To maximise the capacity and life of the rechargeable battery, it should be fully charged for 16
hours before the first use and then fully discharged by using. Then recharge to full capacity (6
hours). This discharging/charging procedure should be done every six months.
ACCESSORIES
Your clipper is equipped with a 7-piece hairstyling set which will allow you to make the haircuts
you want to. Two other accessories complete this set: they can be used for the maintenance
of your appliance: an oil burette to lubricate the blades and a small brush to dispose of the
hair stuck in the blades.

BEFORE YOU START

Make sure that your clipper is clean, properly oiled and in perfect working condition.
Caution: if the blade is not oiled correctly, the appliance will not work properly.
Place a towel around the neck of the person whose hair is to be cut to prevent hair from
falling inside the collar.
Have the person sit on a chair so that his/her head is at your eye's level.
Comb the hair thoroughly and hold the clipper in a relaxed, comfortable grip. This will help
you maintain an accurate cutting control.
OIL
To maintain your clipper in peak condition, the blades should be oiled every few haircuts. Do
not use hair oil, grease or oil mixed with kerosene or any solvent, as the solvent will evaporate
and leave the thick oil which may slow down the blades' motion.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
10
Assembly page 10/48
special
instruction
from
MGC HC 2 R - 080609
Team

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis