Location Of Controls - BOMANN HSM 8006 CB Bedienungsanleitung

• Do not press the clipper head too firmly onto the skin.
Danger of injury.
1 Suspension eye
2 On/Off switch
3 Hair length adjuster
4 Moving blade
5 Fixed blade
Accessories (no illustration))
4 X Comb attachments (lengths: 3 mm, 6 mm, 9 mm, 12 mm)
1 X Protective cap for shaving head
1 X Cleaning brush
Adjust Cutting Length
• First remove the protective cap from the shaving head.
• Fit a comb attachment according to your desired hair length.The size of the hair length
setting is displayed in the center of the comb attachment.
• In order to fit a comb attachment, hold it with the teeth pointing upwards. The labeling
of the comb attachment should remain visible on the back. Slide the comb attachment
GB
onto the shaving head and press it in so that it clicks into place.
Cut Hair / Beard
• Select the cutting length.
• Connect the mains plug to a properly installed isolated ground receptacle 230 V~ /
50 Hz.
• Slide the On/Off switch (2) to position "1".
NOTE:
• Start by using the biggest comb attachment and cut your hair/whisker step by step to
the desired length.
• The hair length adjuster (3) allows you to set the exact cutting length and to use the
comb attachments effectively.
34

Location of Controls