How To Enable Read-Only As User - iStorage DATASHUR PRO+ C Benutzerhandbuch

iStorage datAshur® PRO + C
3. Press KEY button once
Solid RED LED switches to a solid GREEN LED indicating successful User
PIN entry.

6. How to enable Read-Only as User

To set the datAshur PRO
proceed with the following steps.
1. Unlock the datAshur PRO C with your User PIN
+
GREEN LED will be solid indicating successful User PIN entry.
3. Press button number 7 followed by the number 6 button (76)
GREEN and BLUE LEDs will continue to blink.
Note: Once activated, drive access is limited to Read-Only. When datAshur PRO
into a USB port the GREEN LED blinks every two seconds indicating the drive is in Read-Only Mode. Admin can
override User Read/Write settings by enabling/disabling Read/Write in Admin mode.
C to Read-Only in User mode,
+
4. Press KEY button THREE times (triple-click)
Solid GREEN LED switches to blinking GREEN and BLUE LEDs indicating
the drive is awaiting new user defined drive settings.
2. Press the KEY button THREE times (triple-click)
Solid GREEN LED switches to blinking GREEN and BLUE LEDs indicating
the drive is awaiting new user defined settings.
4. Press the KEY button once
GREEN and BLUE LEDs will change to a solid RED LED before switching
to a solid GREEN LED indicating successful Read-Only configuration.
C is unlocked and inserted
+
14
User Manual v1.0