Jam Hang Tight Bedienungsanleitung Seite 3

SET UP
The "Hang Tight" speaker is powered by a rechargeable
battery. The speaker comes pre-charged; however, for
optimal play time, make sure to charge before first use.
A – Unwrap the integrated charging cable and plug the
micro USB end into the charging port on the speaker.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for your
cell phone or pick one up next time you're at the store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 3 hours to get up to 20 hours of play
time; while charging, the light will stay solid red. Once
fully charged, the LED will turn off.
USE
A – TURN ON YOUR SPEAKER
Long press the "play/pause" button for 3 seconds to
turn on your speaker.
B – CONNECTING TO A DEVICE
Once turned on, the speaker will immediately search
for a device to pair to; the LED will blink red and blue
alternately. Enable Bluetooth on your device. From
the Bluetooth menu, select "Hang Tight." When the
device and Hang Tight are connected, you will hear a
tone and the LED light will turn solid blue.
You may also connect your device to Hang Tight
using an aux cord, which is not included. When
plugged in, the light will turn solid red.
Note: Once paired, your device and speaker will
find each other every time, as long as your device's
Bluetooth is on. If you're connecting to a computer,
you may have a few more steps on that end. You'll
have to get that information from the computer
company. Depending on your device, you may be
EN
3hrs
prompted to enter a pairing code. If so, use "0000"
as the code. Holding down the "X" and "O" buttons
at the same time, for 5 seconds, will disconnect
the paired device.
Hang Tight
Hang Tight
20hrs
...3s
0000
0000
...0.5s
3