Electrical Interconnection - Hifonics ZEUS EXTREME ZXT2000/1 Bedienungsanleitung

ENGLISH

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the instal-
lation, because loose connections cause malfunctions, insufficient power supply or interferences.
VEHICLE
BATTERY
+12V
1
Connect the 12 volt terminal of the amplifier to the positive pole of the power capacitor by using a suit-
able cable (refer to the table on the next page). Then connect the positive pole of the power capacitor
to the 12 volt positive pole of the vehicle battery.
ATTENTION: Use for the connection a sufficiently dimensioned cable of at least Ø 25 mm
length of max. 2 meters. If you use a longer cable, the cross-section must be correspondingly larger.
Use a very short cable length from the amplifier to the power capacitor, which should be mounted
close as possible to the amplifier.
REM
2
Connect the turn-on signal from the head unit / car radio (REM) with the REM terminal of the power
capacitor. Then connect the REM terminal of the power capacitor with the REM terminal of the ampli-
fier. Hereby the amplifier and the power capacitor are turning on or off with the head unit / car radio.
Use therefor a suitable cable with a sufficient cross section (0,5 mm
18
LINE INPUT
HIGH VOLTAGE
1.0 - 9.0 V
MIN MAX 10 Hz 100 Hz 50 Hz 20 kHz 0 dB
INPUT SUB
SENS. SONIC
LOW VOLTAGE
0.4 - 3.6 V
ZXT 2000/1
DO NOT COVER AIR VENT
ZXT 2000/1
Min. Ø 25 mm
max. total length of 2.0 m
< 30 cm >
SPEAKER OUTPUT
POWER CLIP
PROTECT
12 dB 30 Hz 70 Hz
LOW BASS BOOST
PASS BOOST FREQ.
1 2 3
+12V REM GND
POWER INPUT
EXTERNAL FUSE REQUIRED
4
with a
2
5 6
DANGER
HIGH VOLTAGE
Turn-on cable to the
head unit (car radio)
Min. Ø 25 mm with a
2
max. total length of 2.0 m
with a total
2
).
2