Disposal/Recycling - Cooper Crouse-Hinds CEAG GHG 432 Betriebsanleitung

Fastening holes of apparatus mounting
plates size 3
Apparatus mounting plate for trellis and wall
Fastening
holes for
control unit
GHG 434
Apparatus mounting plate for pipe mounting
16 16 16 16 16
Cooper Crouse-Hinds GmbH
All manuals and user guides at all-guides.com
Explosion protected control units GHG 43.
mounting
8 Repairs / Overhaul /
Modification Modification Modification Modification Modification
Only original COOPER CROUSE-HINDS /
CEAG parts shall be used for carrying out
repairs.
In the event of damage to the flameproof
encapsulation, replacement of these
components is mandatory. In case of
doubt, the respective apparatus shall be
sent to COOPER CROUSE-HINDS / CEAG
for repair.
Repairs that affect the explosion protection
may only be carried out by COOPER
CROUSE-HINDS / CEAG or by a qualified
electrician in compliance with the
respective national regulations
(EN 60079-19).
Apparatus modifications or design changes
are not permitted; excepted from this is the
fitting of additional cable entries within the
scope of the apparatus approvals or acc. to
the instructions given by the manufacturer.
When replacing individual built-in components
(pushbuttons, etc.) section 6.2 "Opening
apparatus / Electrical connection" shall be
observed.
9 Disposal / Recycling
The respective valid national regulations for
waste disposal shall be observed when
disposing of apparatus.
To facilitate the recycling of individual parts,
parts made of moulded plastic shall bear the
marking for the type of plastic used.
The product range is subject to changes and
additions.