Thule Omnistor 6300 Bedienungsanleitung Seite 9

Technical information
EN
Read these instructions carefully. Warranty voided for incorrect connection.
INSTALLATION OF THE ELECTRONIC CONTROL BOX
1. Install the control box inside the vehicle with screws.
2. Extend the motor wires (+ red & - black) to the control unit.
Also the connection to motor & controlbox should be made with Ø
2,5mm 2 cables, tough to avoid loss of voltage due to the wires own
resistence. The installer might have to use up to Ø 4mm
bridge the distance between PCB & awning, while retaining a minimum of
9V at peak usage of 20A.
3. Connect the awning motor wires to the clamps 4 & 5 (See figure p. 7-8).
Connection wires: open the entrance by pushing gently with a screwdriver
in the rectangle beneath the correct connection. Then place the stripped
wire.
INSTALLATION OF THE SWITCH "AUTO / OPEN"
With this switch, the awning opens with one touch.
Note: the awning should only be opened when the key-contact of the
vehicle is turned off.
4. Install the switch (Ø40) on the desired location.
The switch should be monostable: (ON)-OFF-(ON) / (NC)-NO-(NC)
5. Connect the switch with entrance 1, 2 & 3 of the control box with 3 wires
of Ø 1,5mm
CONNECTION OF THE BATTERY
It is recommended that the awning is connected to the secondary
battery of the vehicle, not the batter of the vehicle, in order to avoid all
disturbances from other appliances.
6. Place an electric cable 2 x Ø 2,5mm
Place a 20A fuse in the + conduction. In order to avoid short-circuit:
do not insert the fuse until the electrical connection is completed.
7. Connect the battery to entrances 6 & 7 of the control box.
6CA902-00
2 .
2 from the control unit to the battery.
2 wire in order to
9