Operating; Working In Automatic Mode; Working In Manual Mode - Strend Pro INDUSTRIAL HP-NT411G Original-Gebrauchsanweisung

EN
temperature or in the event of temperature fluctuations, the accuracy of the manual green laser device
may be adversely affected.
- Avoid a sharp impact or drop of the manual green laser device.
- If you are moving the manual green laser device to another location, turn it off. When switched off, the
swing unit locks, otherwise it could be damaged during steeper movements.
ACCUMULATOR ASSEMBLY / DISASSEMBLY
- Insert the charged accumulator from the front into the appropriate slot on the back of the manual green
laser device.
- Remove the accumulator from the device by pulling it backwards.

WORKING IN AUTOMATIC MODE

- Place the manual green laser device on a horizontal and solid surface or mount it on a 360 ° rotating base
with a rotary knob or tripod.
- Turn on the manual green laser device by sliding the switch to the position
- Immediately after switching on, the manual green laser device emits 1 horizontal, 1 vertical beam and a
laser point from the output openings.
- The automatic leveling compensates for unevenness in the range of self-leveling ± 4 ° automatically.
Leveling is completed when the laser beams stop moving.
- By pressing the button
order (img. 1).
- By pressing the button
- To move or turn off the manual green laser device, slide the switch to the position

WORKING IN MANUAL MODE

- Turn on the manual green laser device by sliding the switch to the position
- To switch the manual green laser device to manual mode, press and hold the button briefly
control panel.
- The manual mode LED lights up red.
- When the automatic leveling is switched off, you can take the manual green laser device freely in your
hands or place it on an inclined surface.
- By pressing the button
order (img. 1).
- By pressing the button
- To move or turn off the manual green laser device, slide the switch to the position
PULSE MODE WITH DETECTOR:
- Use the pulse mode in adverse lighting conditions (bright surroundings, direct sunlight) and over long
distances (up to 60 meters).
- The laser beams flash at a high frequency (invisible to the human eye), allowing them to be detected by a
detector.
- Pulse mode can only be switched on in automatic mode.
- Turn the laser to the desired mode.
- To activate pulse mode, press and hold the button
beam intensity is reduced.

OPERATING

you change the illumination mode of the vertical laser beams in the following
turn on / off the horizontal laser beam (img. 2).
you change the illumination mode of the vertical laser beams in the following
turn on / off the horizontal laser beam (img. 2).
. The pulse mode indicator lights up in green. The
.
. The swing unit locks.
.
on the
. The swing unit locks.