Herunterladen Inhalt Inhalt Diese Seite drucken

Maestro MR902 Bedienungsanleitung Seite 5

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
All manuals and user guides at all-guides.com
- Children or pets should be supervised to ensure that they do not play with the
EN
appliance.
- Do not direct the air flow from the fan on sleeping people, especially on children
or pets.
- It is not recommended to stay directly under permanent air flow for a long time.
- THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT USE THE APPLIANCE
FOR ANYTHING OTHER THAN INTENDED USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it, immediately disconnect it
from the mains without contacting the device itself or the water.
- If there appears smoke, sparkling, strong smell of burning isolation, immediately stop
using the device, disconnect the device from the mains and apply to the nearest service
center.
Operation
Before startup
- Remove all wrap materials and film.
- Make sure that all the parts of appliance don't have damages.
Assembling fan Picture1 (page 2)
Place stand upper and lower parts of the base to form the X base or Cross base (13) and
align the four holes with those on the base pole (10).
Secure the base pole to the cross base with the four screws provided (11, 12,13).
Slide the control panel tube (6) over the upper extension pole (8) onto the base. If
necessary, slightly loosen the screw (7) by turning it counter-clockwise. Tighten the screw
until secure.
Extend upper pole (8) and slide pole connections over upper pole unto base pole
(11,12,13) and tighten.
Attach the motor (5) with speed control panel onto the upper pole (8). Ensure the speed
control panel is pushed fully onto the upper pole and secured tightly with the screw
provided (7).
Unscrew the grill lock nut (16) from the shaft (14).
Position rear grill (3) firmly to the shaft and insert the grill lock nut (16). Fasten by turning
the grill lock nut clockwise.
Push the blades (2) along motor shaft (14). Secure the blade with the blade screw (17) by
tightening counterclockwise.
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis