Carat BS-1253 Bedienungsanleitung Seite 10

Make sure the diamond grinding tool is rotating in the cor-
rect direction. Verify the direction of the arrow on the dia-
mond grinding tool is corresponding the direction of the
arrow on the power tool.
Clean the grinder spindle and all parts to be mounted
before you start. Verify the condition of the fl anges and
diamond grinding tool. The supporting surfaces between
the fl anges and the diamond grinding tool must be clean
and fi t well.
A
B
E
D
• Place the mounting fl ange (B) in such way on the grin-
der spindle (A) the centre-bushing is pointing outwards.
The mounting fl ange must be mounted in such way the
rotation-lock (two fl at surfaces) is corresponding with the
fl at surfaces of the grinder spindle.
• Mount the diamond grinding tool (C) on the mounting
fl ange.
• Push the spindle lock button [7] to lock the grinder spin-
dle. Screw on the clamping nut (D) on the spindle and
tighten it with the two-pin spanner [14]. Make sure the
bushing of the clamping nut is pointing outwards.
After mounting the diamond grinding tool and before swit-
ching on, check that the diamond grinding tool is correctly
mounted and that it can turn freely. Make sure that the dia-
mond grinding tool does not graze against the guard and
extraction hood or other parts.
• When the segments of the diamond grinding tool are
worn and don't reach the surface to grind. Mount the
spacer (E) between the mounting fl ange and the dia-
mond grinding tool. Make sure the bushing is pointing
outwards.
Dismount the diamond grinding tool
You need to dismount the diamond grinding tool before
transporting the power tool, to avoid damaging.
Do not touch the diamond grinding tool before it cooled
down! The diamond grinding tool may become very hot
while operating.
Never push the spindle lock button when the spindle is still
rotating! Otherwise the machine may damage.
10
ENGLISH – ORIGINAL INSTRUCTIONS
• Push the spindle lock button [7] to lock the grinder
spindle.
• Loosen the clamping nut (D) with aid of the two-pin span-
ner [14] and dismount it from the spindle. Remove the
diamond grinding tool (C).
OPERATION INSTRUCTIONS
Work piece clamping
The work piece must be well supported and secured
against sliding, for example by the means of clamping
devices.
Usage
Connect the power tool to an power supply with the same
current as stated on the nameplate.
Connect and switch on the dust extractor.
To start the power tool, slide the ON/OFF-switch [8]
C
towards the front. For continuous operation, press the front
of the switch to lock it.
To stop the power tool, press the rear of the switch so it
returns to the OFF-position.
Check grinding tools before using. The grinding tool must
be mounted properly and be able to move freely. Carry
out a test run for at least one minute with no load. Do not
use damaged, out-of-centre or vibrating grinding tools.
Damaged grinding tools can burst and cause injuries.
Operate the power tool with both hands.
Switch the power tool ON when holding it above the
surface to be grinded. Let the diamond grinding tool reach
is maximum no-load speed before it makes contact with
the surface.
Verify the switch [8] actuates properly and returns
to the 0-position when the rear of the switch lever
is pressed, before plugging in the power tools.
NMHX018
03-01-2017