Troubleshooting; Weak Batteries - HomeMatic IP HmIP-SMI55-2 Montage- Und Bedienungsanleitung

Caution! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batter-
ies into a fire. Do not expose batteries to exces-
sive heat. Do not short-circuit batteries. Doing so
will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
10

Troubleshooting

10.1

Weak batteries

Provided that the voltage value permits it, the motion de-
tector will remain ready for operation also if the battery
voltage is low. Depending on the particular load, it may
be possible to send transmissions again repeatedly, once
the batteries have been allowed a brief recovery period.
If the battery voltage is too weak, this will be displayed
in the Homematic IP app and directly on the device via
the device LED (E) (see „10.4 Error codes and flashing se-
quences" on page 47). In this case, replace the empty
batteries by two new batteries (s. „9 Replacing batteries"
on page 43).
Troubleshooting
45