Description; Use; Battery; Insert Tf Card - Berger & Schroter DH1 Gebrauchsanweisung

4. Description

1) This camera has the following connections: USB interface, TF
card slot and external DC power connector. Three levels power/
mode switch for selection: OFF/TEST/ON;
2) LED light indicator: red means PIR monitoring; white means
image or video recording.

5. Use

5.1. Battery

The use of AA batteries is recommended for the power supply.
Make sure that the positive and negative terminals of the battery
match the symbols on the housing.
If you are not going to use the camera for a long period of time,
remove the battery from the camera to avoid possible damage to
the camera due to leakage; In addition, the camera can also be po-
wered by external DC power (6V/2A), solar panels, etc. In „TEST"
mode, „Low Battery" is shown on the display when the battery is
low.

5.2. Insert TF card

This camera has no built-in memory and therefore cannot be ope-
rated without a TF card. The
TF card supports a capacity of up to 32 GB. Before inserting the
TF card into the TF slot, please check if the capacity of the card
exceeds 32 GB and make sure that the card has been tested.
17