Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Testing the back-up camera system after Installation:
1. Check if the vehicle's negative battery cable (ground) has
been reattached.
2. Turn the ignition key to the accessory position - do not start the
vehicle
3. Engage the parking brake, and put the vehicle´s shifter in the
reverse position (backup lights are lit).
If not already done: Please pair your camera to the monitor (as
described in paragraph Pairing). The System should activate
itself. If not, press the Power-button on the Monitor
4. After testing (and re-adjusting if needed) the unit, all cabling
should be installed permanently. Route all wires behind interior
panels or under carpeting. Use the supplied cable ties to keep
excess wires neat and compact.
Note: Under extremely bright light conditions the screen image
may take a few seconds to stabilise. Please wait until the image
has stabilised before backing up.
Pairing:
Enter the Menu by pressing the MENU button (3) and select the
"Pair" icon with the arrow buttons and press ENTER (3). Shortly
after, press the rubber button on the bottom of the camera until
the signal is received by the monitor.
Backup-Camera-mode: If the device is in standby, press the
ON/OFF (3) to supply power to the monitor. The picture on the
monitor will automatically turn on or switch from another mode to
backup camera mode, when the vehicle is in reverse gear
(monitor receives video signal from backup-camera).
Orientation:
In the Menu "Picture direction" you can change the orientation of
the picture. These different views llow you to mount the camera
Operation
31
Werbung
Inhaltsverzeichnis
