Westfalia WAMFW18 Originalanleitung Seite 11

operator. Always inspect accessories or blades before use and discard immediately if not
in good condition. Never use blades that are worn to a dull edge. Always use sharp blades.
▪ Always ensure all accessories or blades are securely attached to the tool before use and
the securing tool is removed prior to use.
▪ Do not attempt to free a jammed blade or accessory until the power tool has been
disconnected from power.
▪ Inspect the workpiece before use to make sure it is in the correct condition for the fitted
accessory or blade. Remove all nails, staples and other embedded objects prior to starting
work.
▪ Any freely movable workpieces should be secured with a clamp or vice before starting
work.
▪ Always ensure that the lighting is adequate in the work area. Never remove your safety
goggles or glasses to improve your view instead increase the level of lighting or move the
lighting so it specifically illuminates the work area correctly.
▪ Do not operate the power tool near flammable materials. Be especially careful when
cutting wood and metal. Sparks from metal cutting are a common cause of wood dust fires.
▪ Never start the power tool while the blade or accessory is in contact with the workpiece,
and always allow the power tool to reach its full speed before making contact with the
workpiece. Use the variable speed control of the tool (if fitted) to start the tool at the
correct speed for the accessory or blade fitted.
▪ Do not exert additional pressure on the body of the tool: allow the blade or accessory to
do the work. By not exerting additional pressure you maintain a safer stronger grip on the
power tool when it breaks through the material, as well as reducing wear on the power
tool which will extend the power tool's service life. Additional pressure may also bend or
twist the accessory or blade which may cause it to break and cause injury. If the power tool
allows for being held with one or two hands hold with two hands whenever possible.
Always exercise caution when handling this power tool.
▪ Sawing, cutting and abrasive actions create heat. This may affect the workpiece and power
tool. Always monitor the heat level and in the event of excessive heat switch off the power
tool and allow to cool before restarting work. Some power tools depending on design may
be more quickly and effectively cooled by running at high speed without load.
▪ The power tool will draw in dust through the vents on its body. Excessive accumulation of
powdered metal may cause an electrical hazard and destroy the tool. Always ensure the
environment dust level is safe for the tool and ensure the vents are not blocked.
▪ For mains-operated power tools, ensure the cable of the power tool is Always kept behind
the tool and never close to where the accessory or blade is operating.
▪ Do not reach under the workpiece, rest the workpiece on your body, or hold the workpiece
while working on it, as contact with the blade or accessory protruding from the workpiece
can result in serious injury.
▪ Anti-vibration gloves should be worn when operating power tools that produce large
amount of vibration, especially during long-term use.
▪ For power tools with a rotating mechanism and accessories ensure the operator is not
wearing clothes or gloves with frayed threads, cords etc. that could be entangled in the
rotating mechanism dragging the operator's hand into the rotating accessory causing
injury. Always wear tight-fitting work clothes, safety shoes. Remove jewellery and secure
long hair. Never wear fabric-based gloves that can produce strands of material when
operating this type of power tool.
11