Operation - Husqvarna 150BT Mark II Bedienungsanweisung

4. Attach the cable to the flexible hose with the cable
clamp.
Introduction
WARNING:
safety chapter before you use the product.
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture of
gasoline and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
fuel contains less harmful chemicals compared to
regular fuel, which decreases harmful exhaust
fumes. The quantity of remains after combustion is
lower with this fuel, which keeps the components of
the engine more clean.
To mix fuel
Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION:
an octane grade less than 90 RON/87
AKI. Use of a lower octane grade can
1456 - 002 - 06.05.2021

Operation

Read and understand the
Incorrect type of fuel can
Do not use gasoline with
5. Attach the intermediate pipe to the control pipe.
6. Attach the blower nozzle to the intermediate pipe.
Note:
The blower nozzle can only be installed on
the intermediate pipe.
7. For higher air speed, attach the high speed nozzle to
the blower nozzle.
cause engine knocking, which causes
engine damages.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION:
oil for water-cooled outboard engines,
also referred to as outboard oil. Do not
use oil for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION:
the ratio of the mixture drastically when you
mix small quantities of fuel. Measure the
Do not use two-stroke
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
Small errors can influence
7