Herunterladen Inhalt Inhalt Diese Seite drucken

Fuel Safety; Safety Instructions For Maintenance; Assembly - Husqvarna 150BT Mark II Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für 150BT Mark II:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 82
are attached and correctly adjusted. There is a risk that
an open belt can go into the fan of the product.

Fuel safety

WARNING:
instructions that follow before you use the
product.
Do not mix or add the fuel indoors or near a heat
source.
Do not start the product if there is fuel or oil on the
product or on your body.
Do not start the product if the engine has a fuel leak.
Examine the engine for fuel leaks regularly.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the blower pipe and the
control handle on the product
Note:
Lubricate the tubes and flexible hose to make
them easier to assemble.
1. Attach the flexible hose (A) to the pipe angle and the
control pipe (B) with the clamps (C) and (D).
C
6
Read the warning

Assembly

Read and understand the
A
D
B
Always be careful with fuel. Fuel is flammable and
the fuel fumes are explosive and can cause serious
injury or death.
Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is a sufficient airflow.
Do not smoke near the fuel or the engine.
Do not put the product or a fuel container near warm
objects, an open flame, a spark or a pilot light.
Always use approved containers for storage and
transportation of fuel.

Safety instructions for maintenance

WARNING:
instructions that follow before you use the
product.
Stop the engine, remove the spark plug and let the
engine become cool before maintenance and
assembly.
A blocked spark arrestor screen causes the engine
to become too hot which causes damage to the
engine.
If the spark arrestor screen is frequently blocked, it
can be a sign that performance of the catalytic
converter is decreased. Speak to your servicing
dealer to examine the muffler.
2. Attach the handle holder (E) to the control pipe. Align
the handle holder with the flange on the control pipe.
3. Adjust the position of the control handle to a safe
and correct work position. Tighten the knob.
Read the warning
E
1456 - 002 - 06.05.2021

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis