Personal Protective Equipment - Husqvarna 150BT Mark II Bedienungsanweisung

• Make sure that you can move and keep a stable
position. Do a check of the work area for possible
obstacles, for example rocks. Be careful if you
operate the product on a slope.
• Do not put the product on the ground with the engine
on.
• Do not operate the product from high positions, for
example on a ladder.
• Make sure that you can always be heard if an
accident occurs.
• Make sure that the exhaust fume outlet is not
blocked. To prevent damage to the product, keep
obstacles at a minimum distance of 50 cm from the
exhaust fume outlet.
• Do not start the product indoors, in bad airflow or
near flammable material. The engine exhaust fumes
contain carbon monoxide, which can cause carbon
monoxide poisoning. The engine exhaust fumes are
hot and can contain sparks which can start a fire.

Personal protective equipment

WARNING:
instructions that follow before you use the
product.
• Use approved personal protective equipment when
you use the product. Personal protective equipment
cannot fully prevent injury but it can decrease the
degree of injury. Speak to your dealer for more
information.
• Use approved hearing protection. Long-term
exposure to noise can result in permanent hearing
damage.
• Use approved eye protection. If you use a visor, you
must also use approved protective goggles.
Approved protective goggles must agree with the
ANSI Z87.1 standard in the USA or EN 166 in EU
countries.
• Use protective gloves during operation and
maintenance.
• Use protective boots or shoes with non-slip soles.
• Use clothing of strong fabric and of full length. Do
not use jewelry or open shoes. To decrease the risk
on injury, your clothing must be close-fitting but not
limit your movements. Put your hair above your
shoulders to prevent that your hair enters rotating
parts or catches on branches.
• Use breathing protection when there is a risk of dust.
• Keep first aid equipment near.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
1456 - 002 - 06.05.2021
Read the warning
Read the warning
• Do a check of the safety devices regularly. Refer to
Maintenance on page 11 .
• If the safety devices are defective, speak to your
Husqvarna servicing dealer.
To do a check of the muffler
WARNING:
a defective muffler.
WARNING:
hot during and after operation, also at idle
speed. Use protective gloves to prevent
burn injuries.
WARNING:
muffler contains chemicals that may be
carcinogenic. Do not touch the muffler if it is
damaged.
• Regularly do a visual check of the muffler. The
muffler keeps noise levels to a minimum and sends
exhaust fumes away from the operator. Refer to
examine and clean the cooling system on page 12 .
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Use the start/stop switch to stop the engine.
2. Make sure that the engine stops fully.
To see where the start/stop switch is on your product,
Product overview on page 2 .
refer to
Harness safety
Always use the harness when you operate the product.
If you do not use the harness, you cannot operate the
product safely. This can result in injury to you or other
persons. Make sure that the waist belt and chest strap
Do not use a product with
The muffler becomes very
The inner side of the
To
5