Mounting The Device; Screw Mounting - Siemens SIMATIC IFP2200 frameless Benutzerhandbuch

Mounting the device

Installation guidelines
NOTICE
Damage to the device due to the open front
The frameless front does not have a protective enclosure. Electrostatic-sensitive components are destroyed on contact with
wires. The front can warp when shear forces are applied. This can result in damage to the machine or system.
• Observe the safety information on ESD guidelines.
• Do not expose the front to mechanical stress, e.g. during installation.
• Ensure adequate sealing during installation.
• Higher degrees of protection of the device front can only be guaranteed if the mounting seal is intact and lies flush
against the mounting cut-out.
• To guarantee a higher degree of protection, you need to take suitable measures yourself. With correct installation, IP65
can be reached.
• Observe the minimum thickness of the enclosure or control cabinet (material thickness): Height of threaded sleeve = 5.5 mm.
• Observe the length of the M3 screws: Maximum screw-in depth into threaded sleeve = 5 mm.
Note
CAx data
The CAx data for electrical planning (circuit diagrams, data sheets, ePlan macros), for example, are available from the
underlying standard devices. A description of how to obtain this data can be found on the Internet: CAx Download
(https://support.industry.siemens.com/cs/us/en/view/89671877)

Screw mounting

Procedure
1. Insert the device from the front into the prepared mounting geometry of an enclosure or control cabinet.
The following figure shows an example of the 22"device without rear-side electronics. The devices have 22 threaded
sleeves that point to the rear, see the red markings.
2. Insert M3 screws of suitable length (see chapter "Installation guidelines (Page 18)") into each threaded sleeve from the rear
and tighten them with a torque of 0.7 Nm.
18
SIMATIC IFP2200/2400 ITC2200/2400 frameless
A5E48015893-AB, 10/2020