Westfalia Diamant Bedienungsanleitung Seite 10

2.
Carefully take off the solar panel from the rechargeable battery and
take care not do damage the cables between the solar panel and the
circuit board.
3.
Remove the old rechargeable battery from the compartment.
4.
Insert a new rechargeable battery, type Ni-MH, 1.2 V, 850 mAh
(HR06). When doing so, mind the correct polarity as shown on the
bottom inside the battery fitting. Carefully place the solar panel back in
place and re-attach the transparent cover to the housing (press
strongly).
Technical Data
Power Supply:
Housing/Degree of Protection:
Effective Area:
Frequency Range:
Operation:
Electricity Supply:
Interval:
Voltage Reserve:
Readiness for Operation:
Cleaning
 Wipe the housing of the solar mole repeller with a lightly moistened
cloth. Use detergent as needed. Do not immerse the solar mole repeller
in water or any other liquid.
 Do not clean the unit with aggressive chemicals or abrasives in order
not to damage the surface.
 Pay attention to keep the transparent cover of the solar panel clean at
all times to ensure best charging performance of the battery by the
solar panel.
Using
1 rechargeable battery, (HR06),
Ni-MH, 1.2 V, 850 mAh
weather-resistant/IP44
approx. 700 m², depending on
condition of soil
400 Hz ± 50 Hz, self-controlling
ON/OFF Switch
Polycrystalline Solar Cells
approx. 2 sec. ON, approx.
approx. 25 sec. pause time
up to 7 days without exposure to light
immediate operating and charging
function, even at low incidence of light
10