Connecting the power supply
CAUTION
►
Before connecting the device, compare the connection data on the
nameplate of the mains adapter (voltage and frequency) with those of your
mains supply . This data must agree so that the device is not damaged .
♦
Connect the supplied mains adapter to the mains adapter connection
and to a mains socket . The device is now in standby mode .
Inserting batteries
NOTE
►
The device can be operated either with batteries or via the mains power
connection .
►
Use 6 x 1 .5 V type C/Baby/LR14 batteries (not supplied) for battery
operation .
►
When the battery level is low, you will hear a beep and the display
shows Battery low .
1 . Open the battery compartment
the two catches
battery compartment
CLOSE with the corresponding arrows on the catches
compartment
2 . Insert 6 x 1 .5 V type C/Baby/LR14 batteries (not included) into the battery
compartment
shown on the polarity diagram . Make sure that the strip is placed under the
batteries so that they can be easily removed again .
3 . Close the battery compartment
two catches
position . Note also the labels OPEN and CLOSE with the corresponding
arrows on the catches
Aerial
♦
Screw the screw aerial
SBDB 5 A1
e
of the battery compartment
w
can be opened . Note also the labels OPEN and
e
.
e
. Insert the batteries into the battery compartment
e
e
of the battery compartment
w
of the battery compartment
w
into the aerial holder .
i
on the rear of the device by turning
anticlockwise until the
e
w
on the rear of the device and turn the
clockwise into the locked
e
e
GB │ MT
r
1
of the battery
as
e
.
│
47
■