Quick Start - Siemens SITRANS LUT400 Betriebsanleitung

Quick Start Wizards
To configure the SITRANS LUT400 for applications of level, volume (standard vessel shapes), or
Quick Start Wizards via LUI
flow, use the
A wizard for applications employing more complex vessel shapes is available via SIMATIC
Quick Start Wizards via SIMATIC PDM
PDM. See
Other Quick Start Wizards:
Other Quick Start Wizards using various software packages are also available
• SIMATIC PDM (HART)
• AMS (HART)
• FC375/475 (HART)
• FDTs (HART)
Parameter Configuration Charts (to record data prior to configuring device via Quick Start
Wizard) are available on our website. Go to www.siemens.com/sitransLUT400 > Support >
Application Guides.
Quick Start Wizards via LUI
1) Press to enter Program mode.
Choose Wizards (1.), Quick Start (1.1.), and then the appropriate quick start: 
2)
QS Level (1.1.1.), QS Volume (1.1.2.), or QS Flow (1.1.3.). 
[The QS Flow wizard will display on LUI for LUT430 (Pump and Flow), and LUT440 (OCM)
configured models only.]
3) Follow the steps then choose Finish to save Quick Start parameter changes and return to
Program menu, then press
Notes:
• The Quick Start Wizard settings are inter-related and changes apply only after you
choose Finish in the final step.
• Do not use the Quick Start Wizard to modify individual parameters: see instead
Parameter section of full Operating Instructions. (Perform customization for your
application only after the Quick Start has been completed.).
• For more information on any wizard parameter see full Operating Instructions.
1. Wizards

1.1. Quick Start

1.1.1. QS Level
Use this wizard to configure simple level applications.
a) Press RIGHT arrow
MENU.
b) Press RIGHT arrow
c) Press RIGHT arrow
1)
See Communications for SITRANS LUT400 (HART) Manual
7ML19985XU81
described below.
on page 33
three times to return to Measurement mode.
to activate PROGRAM mode and open menu level 1: MAIN
two times to navigate to menu item 1.1.1.
to open QS Level.
SITRANS LUT400 (HART)
.
1)
:
Page EN-17