Siemens SINUMERIK 840D series Installationshandbuch Seite 437

SpacerMark2=
SpacerMark3=
SpacerMarkers appear a spacer will be inserted)
SpacerMarkInsertAfter1=
SpacerMarkInsertAfter2=
SpacerMarkInsertAfter3=
conversion to/from CNC)
CR + LF + LF,
LF + LF + LF,
EOBcode=0
transferred)
SuppressComment=0
after that time, if machine is not in receive mode)
SendTimeout=1
Baudrate as in [COM] section)
SendBaudRate=0
before the data will be send to the machine)
SendDelay=0
[RECEIVE]
of the NC-program. All charakters before will be cut)
ValidData=0
each file after uploading)
ProgramStart=0
each file after uploading)
ProgramEnd=0
0=none -> receive ends after TimeOut (see below)
EofChar=0
bit further more is received (1 ... 600, 0=infinite)
TimeOut=5
;---HeaderSize---: (Size in Bytes to cut from program header after
receiving each file)
HeaderSize=0
receiving each file)
TrailerSize=0
MMP, MMT, AMC, AMP, AMM/E, AMD
Installationshandbuch, 08/2017, A5E33520367A-AG
;---SpacerMarkInsertAfter1..3 ---:(after each line in which this
;SpacerMarkInsertAfter3=M30
;---EOBcode---:
; 5 = CR + CR + CR,
; 9 = LF + CR + CR,
; 13 = CR, 14 = LF
;---SuppressComment---: 0= NO 1 = YES (comments will not be
;---SendTimeOut in minutes---: 0= infinite (job will be cancelled
;---Different Baudrate for sending---: (SendBaudRate=0 = same
;---SendDelay in seconds---: (the system waits for this time
;Program Input Parameter
;---Parameters in ASCII- Dezimal- Code (0 ... 255)---
;---ValidData---: (This charakter shows the first valid character
;---ProgramStart---: (character in ASCII dec. added in front of
;---ProgramEnd---: (character in ASCII dec. trailed at the end of
;---EofChar---: (character, which indicates the end of uploading)
;TimeOut in seconds. Uploading is stopped after this time, if no
;---TrailerSize---: (Size in Bytes to cut from program end after
Manage MyPrograms (MMP) konfigurieren
(This parameter is used for the end of line
6 = CR + CR + LF,
10 = LF + CR + LF,
6.9 Maschinenanschlüsse
7 = CR + LF + CR,
11 = LF + LF + CR,
8 =
12 =
437