AEG L 75480 WD Benutzerinformation Seite 20

20 www.aeg.com
2.
Press the Start/Pause button
The appliance drain the water and
spin.
3. When the programme is completed
and the door lock symbol goes off,
you can open the door
4. Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately
18 hours.
9.11 Drying only
WARNING!
Open the water tap. Put the drain
hose in the sink or connect to the
drain pipe.
• Load the laundry.
• Turn the programme dial to the pro-
gramme suitable for the items to dry.
To have best performances in
drying when you wash the laun-
dry set a spin cycle at the maxi-
mum speed allowed for your
type of items.
You can dry your laundry in two ways:
With the automatic drying:
• press the button
until a black line appears under one of
the dryness level symbol:
• The display shows a time value, calcu-
lated on a default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
• Press the button
gramme.
The drying symbol comes
on.
8 again and again
Extra dry symbol
Cupboard dry symbol
Iron dry symbol
4 to start the pro-
The door locked symbol
comes on.
4 .
You cannot set all levels for all
type of laundry.
With the timed drying:
• Press the button
to set the drying time value (see the
«Programme for timed drying» table).
The display shows a minimum time
value.
• Each time you press this button the
time value increases by 5 minutes.
• After some seconds the time value on
the display changes: the appliance cal-
culates also the duration of the anti-
crease and the cooling phases.
• Press button
gramme. The display shows the new
time value every minute.
If you set the time value of only
10 minutes, the appliance per-
forms only a cooling phase.
At the end of the programme
• The appliance stops automatically.
• The acoustic signals operate.
•
In the display
• The indicator of the Start/Pause but-
ton
4
The last minutes of the drying cy-
cle the appliance performs the
anti-crease and the cooling pha-
ses.
• Press button
pliance. After some minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
The drying symbol starts to
flash.
7 again and again
Set time value
Final time value
4 to start the pro-
The drying symbol starts
to flash.
The door locked symbol
comes on.
comes on.
goes off.
to deactivate the ap-
1