Component Replacement - Bosch HTD 6 Serie Serviceanleitung

en 44 | HTD 6xx, HTD 8xx | Component replacement
6.

Component replacement

Replacing cable
1. Slacken off the two screws on the underside to
unfasten the light box from the stand.
Fig. 7: Underside of light box
1 Fastening screws
!
Secure the counterweight with a locking bolt before
tilting the stand.
2. Place a sheet of paper or a large cloth on the floor to
avoid damaging the stand.
3. Lay the stand on the floor.
4. Slacken off but do not as yet remove the retaining
screws on the side of the laser visor.
|
1 692 106 011 2014-06-23
5. Remove the screws at the top of the stand.
6. Remove the laser visor together with the stand cover.
7. Move the slide until the screws of the pulley bracket
are accessible.
8. Then remove the screws and the pulley bracket.
Robert Bosch GmbH